Table of Contents
Advertisement
Handling of HDD
Do not expose the HDD to
vibrations and shocks.
Due to the environment and handling conditions,
the HDD may be subject to partial damages or
may not be able to read, record, and play back
data. Do not expose the unit to vibrations or
shock, and do not turn off the power during
recording or playback.
If the unit is used in a place with loud sounds,
such as a club or similar venue, the recording
may stop due to sound vibrations. Recording
data on an SD card is recommended in these
places.
Back up data periodically.
The HDD is temporary storage. In order to avoid
erasing data due to static electricity,
electromagnetic waves, breakage, and failures,
back up the data to a PC or DVD disc. (F 114,
125)
If the HDD experiences any
abnormality, back up data
immediately.
Failure in the HDD may produce continuous
noise or choppy sound during recording or
playing back. Continuous use will cause further
deterioration, and may eventually disable the
HDD. If these phenomena are observed, copy
the data on the HDD to a PC, a DVD disc etc.
immediately and contact consumer support.
(F 165, 166)
Once the HDD is out of order, data cannot be
restored.
Operation may stop in hot or cold
environments.
The unit is disabled in order to protect the HDD.
Do not use the unit in low
atmospheric pressures.
The HDD may fail if it is used at altitudes of
3000 m (9800 feet) or higher above sea level.
Transportation
When the unit is transported, turn off the power
and be careful not to shake, drop, or cause
impact to the unit.
16
VQT1Z09
[HDC-HS300]
Falling detection
[
] is indicated on the screen when it detects a
falling state (a weightless state). If the falling
state is detected repeatedly, the unit may stop
the recording or playback operation in order to
protect the HDD.
HDD access lamp [ACCESS HDD]
The lamp illuminates while the HDD is being
accessed (initialization, recording, playback,
deleting etc.).
Do not perform the following operations when
the lamp illuminates. It may damage the HDD
or cause a malfunction in the unit.
Turn the unit off
Insert and remove the USB cable
Expose the unit to vibrations or shock
About disposing of or giving away this unit.
(F 154)
Advertisement
Table of Contents
