Quick Guide - Panasonic HDC-HS300P/PC Operating Instructions Manual

Quick Guide

Charging the battery
Connect the AC cable to the AC adaptor and
the AC outlet.
Insert the battery into the AC adaptor by
aligning the arrows.
Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
Insert the battery until it clicks and locks.
Inserting/removing an SD card
OPEN
Access lamp [ACCESS]
When this unit is accessing the SD card or
built-in memory, the access lamp lights up.
12
VQT1Z09
Charging lamp
[CHARGE]
Lights up:
Charging
Goes off:
Charging completed
1) Open the LCD monitor.
Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever .
3) Insert/remove the SD card.
Face the label side
the illustration and press it straight in as far as
it will go.
Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
Securely close it until it clicks.
How to turn on the power
Turn on the power by changing the mode to
or while pressing the lock release
button .
HDC-TM300
Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
Align with .
Status indicator
HDC-HS300
Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
Align with .
Status indicator
To turn off the power, change the mode to OFF.
in the direction shown in
,