Removing The Lcd Bezel - Packard Bell dot s series Service Manual

Removing the LCD Bezel

1. See "Removing the LCD Module" on page 71.
2. Remove the two (2) screw caps.
3. Remove the two (2) screws.
Step
LCD Bezel
4. Starting from the bottom center of the bezel, pry the bezel upwards and away from the panel. Move along the
edge and down each side until all sides of the bezel are removed.
NOTE: If necessary, use a pry to lift up the outside edges of the bezel.
76
Downloaded from LpManual.com Manuals
Size
M2*4 Ni
Quantity
2
Screw Type
Chapter 3