Connection And Recognition; Connection And Recognition Procedures - Panasonic HDC-DX1 Operating Instructions Manual

Connection and recognition

Connection and recognition
procedures
≥If the recognition procedure is not
accomplished properly, operation will not be
possible after connecting the unit to the
computer.
≥If the unit fails to operate normally it may mean
that the correction procedure was not
conducted properly.
1
Connect this unit to the AC
adaptor.
≥If a battery is used, operation is not
possible when this unit is connected to a
computer.
2
Insert an SD card with recorded
images in this unit and then set
the mode dial to
the power.
3
Connect this unit and a
computer.
to turn on
A
A USB cable (supplied)
This unit is automatically recognised by the
computer.
≥Insert the plugs as far as they will go. The
unit and computer will not operate properly
if the plugs are not inserted fully.
≥Do not use any other USB connection
cables except the supplied one. (Operation
is not guaranteed with any other USB
connection cables.)
≥When the unit is connected to a computer,
the operation mode cannot be changed and
its power cannot be turned off.
In this case, disconnect the USB cable. (l 99)
≥When this unit is connected to a computer, you
cannot use this unit's DISC EJECT lever to
remove a disc.
≥When a computer is accessing the SD card in
this unit, the card access lamp lights. (When a
card is being accessed,
LCD monitor.) Do not disconnect the USB
cable or AC adaptor while the disc or card is
being accessed as it may damage the data.
≥It may be necessary to reboot the computer
after connecting this unit to it for the first time.
With a computer
appears on the
97
VQT1A15