Connecting To The Ac Outlet - Panasonic HDC-DX1 Operating Instructions Manual

Setup
≥The batteries heat up after use or charging.
This unit will also heat up while being used.
This is not a malfunction.
≥Be aware that the operating time of the battery
will become shorter in low temperatures. We
recommend charging a spare battery for use
when recording.
ª About the remaining battery
capacity indication
The remaining battery capacity is displayed in
minutes when using the Panasonic battery that
you can use for this unit. It may take time to
display the remaining battery capacity.
≥The display changes as the battery capacity
reduces.
# #
If there are less than 3 minutes, then
will become red. If the battery discharges, then
will flash.
≥The remaining battery capacity may not be
displayed correctly where the temperature is
low or high or if the battery was not used for a
long period of time.
To correctly display the remaining battery
capacity, recharge the battery, discharge it and
then charge it again. (Even if this operation is
performed, it may not be possible to display the
remaining battery capacity correctly if the
battery was used for a long period of time
where the temperature is low or high or if the
battery was repeatedly charged.)
≥The maximum amount of remaining battery
capacity able to be indicated is 240 minutes. If
the actual remaining time exceeds
240 minutes, the indication will stay green and
will not change until the remaining time falls
below 240 minutes.
≥Depending on the conditions of use, the time
displayed on the remaining battery capacity
indication will change so use it as an
approximation.
28
VQT1A15
90min
# #
.
≥When turning the mode dial to switch modes,
the time indication will turn off in order to
recalculate the remaining battery capacity time.
≥When using batteries made by other
companies the remaining battery capacity will
not be shown.

Connecting to the AC outlet

The unit is in the standby condition when the AC
adaptor is connected. The primary circuit is
always "live" as long as the AC adaptor is
connected to an electrical outlet.
1
Connect the AC cable to the AC
adaptor and the AC outlet.
2
Connect the DC cable to the AC
adaptor.
3
Connect the DC cable to the DC
input terminal DC IN 7.3V.
≥Do not use the AC cable with any other
equipment as it is designed only for this
unit. Do not use the AC cable from other
equipment with this unit.
≥While the DC cable is connected to the AC
adaptor, the battery will not charge.