Panasonic HDC-DX1 Operating Instructions Manual page 108

Others
CANNOT FINALIZE.
CANNOT UN-FINALIZE
THIS DISC.
CANNOT READ DISC.
PLEASE CHECK
CONDITION OF DISC.
CHECK CARD.
CARD LOCKED.
CARD FULL.
TOP MENU COULD NOT
BE CREATED.
CANNOT PROTECT.
CANNOT OPERATE.
INTERNAL TEMPERATURE
IS TOO HIGH.
INTERNAL TEMPERATURE
TOO HIGH. PLEASE TURN
UNIT OFF AND WAIT A
WHILE.
THIS BATTERY CANNOT
BE USED.
CANNOT RECORD IN AGS
MODE.
PUSH THE RESET
SWITCH.
CHECK THE DISC AFTER
PUSHING THE RESET
SWITCH TO REPAIR IT.
CANNOT SET.
CHANGE MODE TO USE
USB.
DISCONNECT USB
CABLE.
108
VQT1A15
The disc cannot be finalized (un-finalized) on this unit. (The disc
was recorded on another device etc.)
Or, you are trying to finalize a disc that has no motion pictures
recorded on it.
There are scratches or dirt on the recording/playback side of the
disc. If there is dirt on the disc, use the supplied cleaning cloth to
wipe it. (l 25) If the disc is scratched, insert a new one.
This card is not compatible or it cannot be recognised by the unit.
The write protection switch on the SD card is set to LOCK. (l 24)
The SD card is full so no further data can be recorded. Delete
unnecessary files (l 77) or insert a new SD card.
Creating a top menu has failed.
There may be scratches or dirt on the recording/playback side of the
disc. If there is dirt on the disc, use the supplied cleaning cloth to
wipe it. (l 25)
Scenes on the DVD-RAM for which top menus have been created
cannot be protected.
The temperature of the unit is high so it cannot be operated. Turn off
the power, wait until the unit cools and then turn on the power again.
Use a battery that you can use for this unit. (l 27)
If using a Panasonic battery compatible with this unit (l 27), eject
the battery and then insert it again. If the message appears even
after repeating this several times, this unit needs repair. Detach the
power and consult the dealer who you purchased this unit from. Do
not attempt to repair it by yourself.
The AGS function is activated. (l 44)
An irregularity in the unit has been detected. Press the RESET
button to restart the unit. (l 116)
There may be scratches or dirt on the recording/playback side of the
disc. If there is dirt on the disc, use the supplied cleaning cloth to
wipe it. (l 25) If the disc is scratched, insert a new one.
The [GUIDE LINES], [ZEBRA], [MF ASSIST] and [MIC LEVEL]
menu settings cannot be set when the colour bar is set.
The USB cable is connected in recording mode.
The unit cannot correctly establish the connection to the computer
or printer. Disconnect and then reconnect the USB cable.