Table of Contents
Advertisement
FEATURES AND SPECIFICATIONS
Installation Choices
¥
LIGHTWEIGHT BLOCK-IN: The lightweight block-in installation utilizes a masonry
enclosure around the Fireplace Xtrordinair yet still allows the use of a metal chimney.
This type of installation can be used in the place of a zero clearance fireplace, giving a
home a heat producing masonry fireplace without the cost of a masonry chimney.
¥
MASONRY INSTALLATION: A full masonry installation gives the look of a masonry
fireplace both inside and outside the home. This gives a home the distinction of quality.
¥
EPA Phase II approved.
¥
Heavy duty steel construction.
¥
Large firebox capacity - 4.3 cu. ft.
¥
Long burn time - 12 Hours.
¥
Large glass doors for maximum
visibility.
¥
Firebrick lining for firebox
protection.
¥
388 CFM blower for convection
heat and outside combustion air.
¥
Thermostat for automatic control of
the blower.
Heating Capacity ............................................................................ up to 3000 sq. ft. maximum
Overall Efficiency ............................................................................ 77 % (DEQ Method)
Emissions grams/hr........................................................................ 2.3 (EPA Method)
Maximum Burning Time................................................................. 12 Hours
Flue Opening Diameter ................................................................ 8 in.
Overall Width (Not Including Faceplate)..................................... 39 in.
Overall Depth................................................................................... 23 in.
Fuel.................................................................................................... Solid Wood or Natural Gas
BTU Output/hr.................................................................................. 10,700 to 75,700
Emissions, Efficiency, Heating Capacity and Burn Times may vary depending
on actual home floor plan, type of fuel used, and moisture content. Emissions
and efficiency numbers are those that have been certified by the U.S. E.P.A.
and the Oregon Department of Environmental Quality.
¥
Gas line sleeve through the left
side of the firebox for easy
installation of gas log lighter or
gas log set.
¥
8' leads for the power source and
the blower. (110 Volts A.C.)
¥
Set-up face that is on fireplace
during installation to prevent
damage to the decorative face
plate. It is also slightly larger
than the decorative face plate to
provide for heat expansion.
¥
3 blower duct locations for a wide
selection of blower installation
options.
Page 2
Advertisement
Table of Contents
