Table of Contents
Advertisement
LIGHTWEIGHT BLOCK-IN - SPECIFICATIONS (Cont.)
Facing (Continued)
Square or Arched Faceplate
The set-up face shipped with the fireplace is for a square faceplate. To use the arched set-up
face, the top and two side pieces of the square set-up face will need to be removed. Loosen
the six set-up face screws and pull the three pieces from behind the arched set-up face, then
re-tighten the set-up face screws (see the illustration below).
Side square
set-up face
extension
Top square set-up face extension
Loosen these screws on each
side to remove the square
set-up face extensions.
Arched set-up face
Page 12
Slide the square
set-up face
extensions from
behind the arched
set-up face.
Advertisement
Table of Contents
