With Bluetooth Device Using Nfc - Sennheiser PXC 550 Instruction Manual

Getting started
18 | PXC 550
Pairing the headphones with a Bluetooth device using NFC
The following sections describe, using a smartphone as an example, how to pair
your PXC 550 Wireless headphones with a Bluetooth device using NFC. If the
instructions provided do not work on your device, proceed as described in the
instruction manual of the device.
Switch the headphones on and ensure that Bluetooth is activated on the
headphones when performing this procedure.
1. Activate NFC on your smartphone.
2. Scan the smartphone to the NFC panel on the left
headphones.
The LEDs flash white in sequence and you hear the voice prompt "pairing".
The headphones are in pairing mode.
At this point, if you decide to cancel pairing, press the Effect Mode Control
button once. You hear the voice prompt "pairing cancelled" after a few
seconds.
3. Click "Yes" if the pairing confirmation dialog appears on the screen of your
smartphone (this step may vary depending on your smartphone).
If pairing was successful, you hear the voice prompt "connected". The LED
flashes white 3 times.
Menu
Menu
NFC on
NFC o
NFC o
› power on ‹
› pairing ‹
If no connection is established, you hear the voice prompt "no device
found". After trying to connect for 5 minutes, pairing mode is terminated
and the headphones return to the disconnected state. Restart the
headphones by switching them off and on again, and repeat the pairing
procedure.
ear cup of the
L
Left
Connect to Bluetooth device?
Yes
No
› connected ‹
3X