Clearing Previously Paired Devices - Sennheiser PXC 550 Instruction Manual

Troubleshooting

Clearing previously paired devices

Ensure that Bluetooth is activated on the headphones when performing this
procedure.
1. Restart the headphones by switching them off and on again (see pages 22
and 23).
2. Press the Effect Mode Control button for 4 seconds.
You hear tones and the voice prompts "phone x disconnected" and "pairing"
and the LEDs flash white in sequence.
3. Press the Effect Mode Control button again for 4 seconds until you hear tones
and the voice prompt "pairing list cleared".
The LEDs flash white in sequence. The headphones are permanently
disconnected from all devices and go into pairing mode.
› power off ‹
› power on ‹
Effect Mode Control
Effect Mode Control
4s
› pairing list cleared ‹
4s
PXC 550 | 47