Pairing The Earphones With A Bluetooth Device - Sennheiser MOMENTUM True Wireless 2 Instruction Manual

Using the earphones
The right and the left earbud also use a Bluetooth wireless con-
nection. Both earbuds are paired with each other upon delivery.
If you use another earbud (e.g. a replacement earbud), the two
earbuds must also be paired with each other (> 35).
Pairing the earphones with a Bluetooth
device
1
max. 1 m/40 inch
3 4
ON
1. Take both earbuds out of the charging case and insert them into
your ears (> 21). The distance between the earbuds and the Blue-
tooth device should not exceed 40"/1 m.
2. Simultaneously touch and hold the right and the left touch control
panel for 3 seconds until you hear the voice prompt "Pairing" and
a beep.
The LEDs of the earbuds flash blue and red. The earbuds are in
pairing mode.
3. Activate Bluetooth on your Bluetooth device.
4. Via the menu of your Bluetooth device, start the search for new
Bluetooth devices.
All active Bluetooth devices in the proximity of your smartphone
are displayed.
From the list of found Bluetooth devices, select "MOMENTUM TW
2". If necessary, enter the default pin code "0000".
If pairing was successful, you hear the voice prompt "Pairing suc-
cessful" and the LEDs of the earbuds flash blue 3x.
If no connection is established within 1 minute, pairing mode is
terminated and the earbuds switch to idle mode. If necessary,
repeat the steps described above.
If the earphones are not paired with any Bluetooth device (the
pairing list is empty), pairing mode is permanently active.
2
"Pairing"
3s
************
*********
MOMENTUM TW2
MOMENTUM True Wireless 2 | 17
"Pairing
successful"
3x