Table of Contents
Advertisement
Adjusting handset
Ringer volume
3 levels (high/low/off) are available.
Make sure the handset is idle.
1. Press œ–
2. Press & to select "Ringer volume".
Display:
3. Press ).
4. Press & or % to select the desired volume.
The current ringer will sound.
To change the volume, press & or %
again within 5 seconds.
Adjusting base unit
Ringer volume
4 levels (high/middle/low/off) are available.
While the unit is idle, press + or -.
If any documents are in the document entrance,
you cannot adjust the ringer volume. Confirm
that there are no documents in the entrance.
To turn the ringer off:
1. Press - repeatedly until the following is
displayed.
Display:
2. Press w.
To turn the ringer back on, press +.
While the ringer volume is set to off:
When a call is received, the unit will not ring and
will display the following.
Ringer pattern
You can select one of three ringer patterns. Change
the setting (feature #17 on page 71). The ringer
pattern you selected will sound when the unit receives
a call.
volume!
.
0Save0directory
H
Ringer0volume
GF
H
=Yes
volume!
RINGER OFF= OK?
YES:SET/NO:STOP
RINGER OFF
INCOMING CALL
To turn the ringer off:
Press and hold & until you hear 2 beeps
in step 4.
To turn the ringer back on, press % in
step 4.
While the ringer volume is set to off:
When receiving a call, the handset will not
ring.
Handset receiver volume
3 levels (high/middle/low) are available.
While talking, press & or %.
Speaker volume
8 levels (high to low) are available.
While using the speakerphone, press
+ or -.
Fax voice guidance
volume
9 levels (high to off) are available.
While listening to the fax voice
guidance, press + or -.
Answering device
volume
9 levels (high to off) are available.
While listening to the recorded
messages, press + or -.
Volume
12Ringer1off
23
Advertisement
Table of Contents
