Table of Contents
Advertisement
Volume
2.5 Adjusting cordless handset
volume
{^}{V}{<}{>}
Ringer volume
1. "
2. Select N by pressing {^}, {V}, {<}, or {>}. i #
3. Press {^} or {V} to select "Ringer Setup". i
#
4. Press {^} or {V} to select "Ringer Volume". i
#
5. Press {^} or {V} to select the desired volume. i
# i {ih}
Note:
L When receiving a call, you can adjust the ringer
volume by pressing {^} or {V}.
L When the ringer volume is turned OFF, U is
displayed.
When the ringer is turned OFF, the cordless handset
will ring for alarm and intercom calls.
Ringtone
You can select the desired cordless handset ringtone for
outside calls and intercom calls (page 53). Caller ID
service users can also use a different ringer for each
category (page 26).
Cordless handset receiver volume
While using the receiver, press {^} or {V}.
Speaker volume
While using the speakerphone, press {^} or {V}.
2.6 Adjusting base unit volume
{ih}
Ringer volume
While the unit is idle, press {A} or {B}.
To turn the ringer OFF
Press {B} repeatedly to display "RINGER OFF= OK?".
i {SET}
Ringtone
Handset receiver volume
While using the receiver, press {A} or {B}.
Speaker volume
While using the speakerphone, press {A} or {B}.
{SET}
{A}{B}
L If there are any documents in the document
entrance, you cannot adjust the volume. Confirm that
there are no documents in the entrance.
L The base unit will not ring for outside calls.
The base unit will ring at the low level for intercom
calls.
L To turn the ringer back ON, press {A}.
L You can select the desired base unit ringtone for
outside calls (feature #17 on page 47).
2. Preparation
17
Advertisement
Table of Contents
