Connecting Tagmastore Ams And Tagmastore Wms Subsystems; System Parameters For Connecting Tagmastore Ams And Tagmastore Wms Subsystems; System Parameter Settings (Tagmastore Ams And Tagmastore Wms Subsystems) - HP StorageWorks XP12000 User Manual

Connecting TagmaStore AMS and TagmaStore WMS
subsystems
System parameters for connecting TagmaStore AMS and TagmaStore WMS
subsystems
Table 17 explains whether to specify system parameters when making settings for ports on TagmaStore
AMS and TagmaStore WMS subsystems.
NOTE:
When connecting to a TagmaStore AMS or TagmaStore WMS subsystem, use LUN Manager to set the
data transfer speed of the XP12000/XP10000/SVS200 external port you use to a fixed value other than
Auto Negotiation. Also, set the data transfer speed of the target port of the TagmaStore AMS or TagmaStore
WMS subsystem to the same fixed value according to the data transfer speed of the external port.
Table 17 System parameter settings (TagmaStore AMS and TagmaStore WMS subsystems)
Pane
name
Boot
Options
System
Parameter
Parameters
Start Attribute
• Single Mode
• Dual Active Mode
Delay Planned Shutdown
Drive blocking mode
Vendor ID
Product ID
ROM Microprogram Version
RAM Microprogram Version
Option
Operation if the processor
failure occurs
External Storage XP user guide for the XP12000, XP10000, SVS200
Parameter setting
Specify this parameter when the TagmaStore AMS or
TagmaStore WMS subsystem is in the one-controller
configuration.
Specify this parameter when the TagmaStore AMS or
TagmaStore WMS subsystem is in the two-controller
configuration.
You can either specify this parameter or omit specifying this
parameter.
You can either specify this parameter or omit specifying this
parameter.
Keep this parameter as HITACHI (default), and do not change.
Keep this parameter as DF600F (default), and do not change.
You can either specify this parameter or omit specifying this
parameter.
You can either specify this parameter or omit specifying this
parameter.
You can either specify this parameter or omit specifying this
parameter.
Set this parameter to Reset of occurred.
169