Connecting Thunder 9500V subsystems
System parameters for connecting Thunder 9500V subsystems
Table 13
explains whether to specify system parameters when making settings for ports on the Thunder
9500V subsystem.
Table 13 System parameter settings (Thunder 9500V subsystems)
Pane name
System Startup Settings
Common 1
OPTION 1
OPTION 2
Data Striping
Inquiry Setting
164
Notes on connecting external arrays
Parameter
Start Attribute
•
Single Mode
•
Dual Active Mode
•
Hot Stand-By Mode
Delay Planned Shutdown
SCSI Fibre Channel
Common Options
SCSI Fibre Channel
Common Options
Operation if the processor
failure occurs
Command Queuing
Mode
Vendor ID
Product ID
Parameter setting
Specify this parameter
when the Thunder 9500V
subsystem is in the
one-controller
configuration.
Specify this parameter
when the Thunder 9500V
subsystem is in the
two-controller
configuration.
NOTE:
Be sure to specify that
Data Share Mode will
be used.
Do not specify this
parameter.
You can either specify this
parameter or omit
specifying this parameter.
You can either specify this
parameter or omit
specifying this parameter.
You can either specify this
parameter or omit
specifying this parameter.
Set this parameter to
Reset of occurred.
Set this parameter to ON.
Keep this parameter as
HITACHI (default), and do
not change.
Keep this parameter as
DF600F (default), and do
not change.