Connecting The Battery - Miller Big Blue 700 Duo Pro DLX SF Owner's Manual

5-4. Connecting The Battery

Tools Needed:
1/2 in.
NOTICE − Lead acid batteries discharge
when stored in any temperature. Units that
are stored should have the battery
recharged every three months and before
being put into service. To preserve opti-
mum battery performance and life,
recharge battery in storage when the
open−circuit voltage drops to 12.4 volts
DC when measured across the battery
terminals.
!
Connect negative (−) cable last.
NOTICE − Wait two minutes after engine
shutdown before disconnecting battery or
engine controller may be damaged.
Notes
OM-252624 Page 28
.
Complete Parts List available at www.MillerWelds.com
+
−
Battery is most easily accessed through
the rear panel. Remove battery access
panel from rear panel. Connect battery,
negative cable last. Reinstall battery ac-
cess panel.
S Do not allow the battery cables to
touch opposing terminals. When con-
necting the battery cables attach the
positive (+) cable to the positive (+)
battery terminal first, followed by neg-
ative (−) cable to negative (−) battery
terminal.
Conn_batt1 2014−11 802 168-E / S-0756-C
S Never start the engine when the
cables are loose or poorly connected
to the battery terminals.
S Never disconnect the battery while
the engine is running.
S Never use a quick battery charger to
start the engine.
S Do not charge battery with Engine
Control switch On.
S Always disconnect the negative (−)
battery cable before charging battery.