Assembly - Pro-Form 330 RT PETL40131 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Assembly requires the included hex key
and your own phillips screwdriver
For help identifying the assembly hardware, refer to the drawings below. Note: The assembly hardware and
other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so.
3/8" Star Washer
(45)–2
U-nut (105)–4
1/2" Screw (84)–2
Silver Ground
Screw (87)–1
3" Bolt (2)–4
5" Bolt (10)–2
WARNING:
Do not plug in the power
cord until the treadmill is completely assembled.
1. Open part bag A. Identify the Right Upright (89), which
has a large round hole near the lower end.
See drawing 1a. Slide two U-nuts (105) into the lower
end of the Right Upright (89) as shown. Insert two U-
nuts into the Left Upright (not shown) in the same
way.
See drawing 1b. Attach the Left and Right Uprights (88,
89) to the Base (71) with four 3" Bolts (2) and four 5/16"
Washers (31). Make sure that the Uprights are ori-
ented so the indicated plates are facing each other.
In addition, make sure that the Base is oriented so
the Base Pads (19) are in the location shown.
and adjustable spanners .
5/16" Washer 1/4" Washer
(31)–4 (108)–4
3/4" Screw (90)–10
Crossbar Screw (69)–2
1" Bolt (12)–6
1
1a
Hole
89 105
1b
88
Plates
89
71
31
2
19
6
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand as
shown. Using your left hand, pull the latch knob to the left
and hold it. Pivot the treadmill down until the frame is past
the latch pin. Slowly release the latch knob.
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. To decrease the possibility of in-
jury, bend your legs and keep your back straight.
89
31
2
19
Latch
Knob
Latch
Pin
15