Advertisement
ASSEMBLY
Assembly requlres two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly
requires your own Phllllps screw-
driver _
and rubber mallet _.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred
to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance.
If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive
cleaner.
1. W'rth the help of a second person, carefully raise the
treadmill to the upright position.
While a second person tips the treadmill to one side
slightly and holds it, Insert one of the Extension Legs (103)
Into the treadmill as shown. Make sure that the Extension
Leg is turned so the Base Pad (97) is on the bottom.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the slde of the treadmill so that both Extension
Legs
(103) am resting flat on the floor.
97
2. W'_h the help of a second person, carefully lower the
treadmill frame and then tip the Updghts (82) down as
shown. Make sure that the Extension Legs (1 03) re-
main in the Uprights.
Attach each Extension Leg (103) With two Screws (101 )
and a Base Pad (119) as shown.
Note: One replacement Base Pad (119) and Spacer (not
shown) may be Included. If a Base Pad becomes wom
and needs to be replaced, use the replacement Base
Pad. If a Thtck Base Pad (97) needs to be replaced, use
the replacement Base Pad with the Spacer.
3. W_h the help of a second person, carefully tip the
Uprights (82) back to the vertical position.
Attach the Latch Assembly (9) to the left Upright (82) with
the two 1/2" Screws (89).
3
,101
89
9
Advertisement
