Before You Begin; Maintenance And Troubleshooting - Pro-Form 330 RT PETL40131 User Manual

MAINTENANCE AND TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please call our Customer Service Department.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet. (See page 10.) If an ex-
tension cord is needed, use only a 3-conductor, 1mm
(5 ft.). IMPORTANT: The treadmill is not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill
near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
PROBLEM: The power turns off during use
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the
circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call our Customer Service Department.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. Remove the screws from
the hood, and carefully remove the hood.
Locate the Reed Switch (46) and the Magnet (49) on
the left side of the Pulley (53). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch is about 3 mm (1/8 in.). If necessary, loosen
the Screw (26) and move the Reed Switch slightly.
Retighten the Screw. Re-attach the hood, and run the
treadmill for a few minutes to check for a correct
speed reading.
2 (14-gauge) cord that is no longer than 1.5 m
c
Tripped Reset
Tripped Reset
a
3 mm
53
26
49
46
Top View
16

BEFORE YOU BEGIN

Thank you for selecting the PROFORM ® 330 RT tread-
mill. The 330 RT treadmill combines advanced tech-
nology with innovative design to let you enjoy an excel-
lent form of cardiovascular exercise in the convenience
and privacy of your home. And when you're not exer-
cising, the unique 330 RT treadmill can be folded up,
requiring less than half the floor space of other tread-
mills.
For your benefit, read this manual carefully before
using the treadmill. If you have questions after read-
Water Bottle Holder
(Bottle not included)
Key/Clip
Storage Latch
LEFT SIDE
Foot Pad
Walking Belt
Rear Roller
Adjustment Bolts
ing this manual, please call our Customer Service
Department at 08457 089 009. To help us assist you,
please note the product model number and serial num-
ber before calling. The model number of the treadmill
is PETL40131. The serial number can be found on a
decal attached to the treadmill (see the front cover of
this manual for the location of the decal).
Before reading further, please review the drawing
below and familiarise yourself with the labelled parts.
Console
Handrail
RIGHT SIDE
Hood
Circuit Breaker
Front Wheel
Incline Leg
5