Operation And Adjustment - Pro-Form 330 RT PETL40131 User Manual

OPERATION AND ADJUSTMENT

THE PERFORMANT LUBE TM WALKING BELT
Your treadmill features a walking belt coated with PERFORMANT LUBE
TANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such
substances will deteriorate the walking belt and cause excessive wear.
HOW TO PLUG IN THE POWER CORD
This product must be earthed. If it should malfunction or break
down, earthing provides a path of least resistance for electric
current to reduce the risk of electric shock. This product is equipped
with a cord having an equipment-earthing conductor and an earth-
ing plug.
Two power cords are included. Select the one that will fit your
outlet. Refer to drawing 1. Plug the indicated end of the power
cord into the socket on the treadmill. Next, lift the tab on the
ferrite box and clamp the ferrite box around the power cord.
Fasten the included plastic tie just behind the ferrite box and
cut off the excess plastic tie. This will prevent the ferrite box
from sliding along the power cord. Refer to drawing 2. Plug the
power cord into an appropriate outlet that is properly installed
and earthed in accordance with all local codes and ordinances.
Note: In Italy, an adaptor (not included) must be used between
the power cord and the outlet. Important: The treadmill is not
compatible with GFCI-equipped outlets.
If the power cord is damaged, it must be replaced with a manufac-
turer-recommended power cord.
DANGER:
Improper connection of the equipment-earthing conductor can result in an in-
creased risk of electric shock. Check with a qualified electrician or serviceman if you are in doubt as
to whether the product is properly earthed. Do not modify the plug provided with the product—if it
will not fit the outlet, have a proper outlet installed by a qualified electrician.
TM , a high-performance lubricant. IMPOR-
1
Socket on treadmill
Ferrite Box
Plastic
Tab
2
Outlet
10
CONSOLE DIAGRAM
Tie
Note: If there is a thin sheet of
plastic on the console, remove it.
CAUTION:
console, read the following precautions.
• Do not stand on the walking belt when turn-
ing on the power.
• Always wear the clip (see the drawing
above) while operating the treadmill.
• Adjust the speed in small increments to
avoid sudden jumps in speed.
• To reduce the possibility of electric shock,
keep the console dry. Avoid spilling liquids
on the console and place only a sealed
water bottle in the water bottle holder.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in (see page 10).
Next, stand on the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothes.
Displays
Key
Clip
Insert the key fully into the console. After a moment,
the displays will light. Test the clip by carefully tak-
Before operating the
ing a few steps backward until the key is pulled
from the console. If the key is not pulled from the
console, adjust the position of the clip.
Follow the steps below to operate the console.
Insert the key fully into the console.
1
A few seconds after the key is inserted, the dis-
plays will light.
Press the Start button or the Speed
2
start the walking belt.
A moment after the button is pressed, the walking
belt will begin to move. Hold the handrails and
begin walking.
As you exercise, change the speed of the walking
belt as desired by pressing the Speed buttons.
Each time a button is pressed, the speed setting
will change by 0.1 mph; if a button is held down,
the speed setting will change in increments of 0.5
mph. Note: The console can display speed and
distance in either miles or kilometers (see
SPEED DISPLAY on page 12). For simplicity, all
instructions in this section refer to miles.
11
Pulse Sensor
button to