Upgrading Your Software - NEC UX5000 Hardware Manual

Chapter 2 - PCB Installation and Startup
8. If there are any existing files on the USB flash drive, you must delete or move any files off the card
before proceeding.
9. Open the directory containing the system software files to be used for the system update.
10. Select all the files within the folder and copy them to the USB flash drive.
This can be done as follows:
- From the software directory window, click: Edit - Select All - Edit - Copy
- From the USB flash drive window, click Edit - Paste
●
The files are then copied from the PC to the USB flash drive.
2.9.8

Upgrading Your Software

Fast Ethernet CN7
Status LED1
BGM/EXSP
Control CN10
USB/CN5
Status LED2
Status LED3
Status LED4
Status LED5
Serial/CN6
BGM/EXSP
Control/CN8
BGM/EXSP
Control/CN9
Load/SW1
2 - 88
As a precaution, it is recommended that the customer database be
saved prior to updating the system software. Refer to Backing Up/
Restoring a Database (page 2-86).
SW6
CN4
Battery
CN3
CN1
CN2
MEMDB
VOIPDB
Gbit Ethernet
<VOIPDB>
Chapter 2