Advertisement
Setting the ONA to factory defaults
The following parameters are the ONA factory defaults:
* Management IP Address :
* Management IP Subnet Mask :
* Default Gateway IP Address :
* Primary DNS Server IP Address :
* Secondary DNS Server IP Address :
* DNS Domain Name :
* SDN Controller IP Address or Name :
* Syslog Server IP Address :
* Operational Mode : 0
* Password :
NOTE: All the fields are empty except the Operational Mode,
which is 0 for the SDN Controller Mode.
Use the following procedure if you want to reset the ONA to the
factory default parameters:
1.
Wait until the ONA starts and the Status LED flashes green.
(You can enter this mode anytime after the ONA starts.)
2.
On the Device side of the ONA, insert a paper clip into the
reset switch and depress it for at least five seconds. This
action clears the parameters so they are all empty fields
(except for Operating Mode) and then resets the ONA.
© 2016 Avaya Inc.
9
NN48800-300 01-07
(700511108)
Advertisement
