Servicing The Engine Oil And Filter; Adjusting Throttle - Toro 03806 Operator's Manual

5. Install the cover orienting the rubber outlet valve in
a downward position—between approximately 5:00
to 7:00 when viewed from the end.
6. Reset the indicator (Figure 52) if it shows red.
Servicing the Engine Oil and
Filter
Service Interval: After the first 50 hours
Every 150 hours
Change oil and filter initially after the first 50 hours of
operation, thereafter change oil and filter every 150
hours.
1. Remove drain plug (Figure 56) and let oil flow into
drain pan. When oil stops, install drain plug.
1
1
1. Drain plugs
2. Remove oil filter (Figure 57). Apply a light coat of
clean oil to the new filter seal before screwing it on.
Do not over-tighten.
1. Oil filter
3. Add oil to the crankcase. Capacity is 7.5 qt. (7 L)
with filter.

Adjusting Throttle

1. Position throttle lever forward so it stops against
seat base slot.
G000766
Figure 56
Figure 57
2. Loosen the throttle cable connector on the lever arm
at the injection pump (Figure 58).
1. Injection pump lever arm
3. Hold the injection pump lever arm against the high
idle stop and tighten the cable connector.
Note: When tightened, the cable connector must be
free to swivel.
4. Torque the lock nut, used to set the friction device on
the throttle lever, to 40-55 in-lb. The maximum force
required to operate the throttle lever should be 20 lb.
38
Figure 58
2. Connector