Toro 03806 Operator's Manual page 16

3. On lift arms #6 and #7, position the brackets and
U-bolts 14.5 inches behind the center line of the
pivot knuckle (Figure 12). Rotate the brackets 10
degrees to the outboard side of the machine.
4. Tighten all the U-bolt nuts to 38–48 ft-lbs.
5. Mount a lift chain to each chain bracket with a screw,
washer and nut, positioning as shown in Figure 13
1. Lift chain
Adjust the Rear Shield
Under most conditions, best dispersion is attained
when the rear shield is closed (front discharge). When
conditions are heavy or wet, rear shield may be opened.
To open the rear shield (Figure 14), loosen the cap screw
securing the shield to the left side plate, rotate the shield
to the open position and tighten the cap screw.
Figure 12
Figure 13
2. Chain bracket
1. Rear shield
Mount the Counter Weights
All cutting units are shipped with the counter weight
mounted to the left end of the cutting unit. Use the
following diagram to determine the position of the
counter weights and reel motors.
1. On the #2, #4 and #6 cutting units, remove the 2
cap screws securing the counter weight to the left
end of the cutting unit. Remove the counter weight
(Figure 16).
16
Figure 14
2. Cap screw
Figure 15