Lubrication; Greasing The Bearings And Bushings - Toro 03806 Operator's Manual

Maintenance Check Item
Check the hydraulic filter indicator.
Check the hydraulic hoses for damage.
Check for fluid leaks.
Check the tire pressure.
Check instrument operation.
Check the reel-to-bedknife adjustment.
Check the height-of-cut adjustment.
Lubricate all grease fittings.
Touch up damaged paint.
1. Check the glow plug and injector nozzles if hard starting, excess smoke, or rough running is noted.
2. Check with the engine running and oil at operating temperature.
3. Immediately after every washing, regardless of the interval listed

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If machine is operated under normal conditions,
lubricate all bearings and bushings after every 50 hours
of operation or immediately after every washing.
The grease fitting locations and quantities are:
• Cutting unit carrier frame and pivot (2 ea.)
(Figure 43)
Figure 43
• Rear axle tie rod (2) (Figure 44)
• Steering cylinder ball joints (2) (Figure 44)
For the week of:
Mon.
2
3
G000751
Tues. Wed. Thurs.
• King pin bushings (2) (Figure 44). The top fitting
on the king pin should only be lubricated
annually (2 pumps).
1. Top fitting on king pin
• Front lift cylinders (3) (Figure 45 and Figure 46
35
Fri. Sat.
1
G000752
Figure 44
Sun.