Table of Contents
Advertisement
3. Installation
This installation guide provides the basic instructions on installing an EZN bullet IP camera. For
details, please refer to the User's Manual in the software CD.
3.1 Mounting and Wiring
Follow the steps below for mounting and wiring the camera.
1.
Before screwing the camera to the wall, drill four holes on the wall according to the
hole-positions on the supplied Quick-Mounting Ring. If you wish to run the wires into the
wall, drill another hole in the middle of the circular area within the Quick-Mounting Ring.
Circular Area
2.
Push the four supplied Anchors into the four holes on the wall. Place the Quick-Mounting
Ring against the anchoring surface so that the holes line up. Screw the Quick-Mounting
Ring to the wall using the supplied Long Screws.
Long Screws
This conduit Is for wiring the cables along
the wall installation.
Quick-Mounting Ring
Anchors
Plug
If you want to wire the cables through the wall,
then this conduit will not be used. You can
insert the supplied Plug into the conduit.
Wall
4
EZN7221/7260/7360
Advertisement
Table of Contents
