Fabrication Of The Connection Cable; A-4-1 Cable Processing - Omron NB3Q-TW00B Setup Manual

A-4

Fabrication of the Connection Cable

Fabricate the connection cable following the procedures below.
A-4-1 Cable Processing
1
Cut the cable to the required length.
2
Use a tool like a razor, etc. to cut off the ethylene peel of the cable. Be care not to damage the
shielding layer (for grouping purpose)
3
Use a pair of scissors to snip off the shielding layer.
4
Bring out the core of each wire using a wire stripper.
5
Fold back the shielding layer.
6
Wrap the folded part of the shielding layer with aluminum foil tape.
NB-series Programmable Terminals Setup Manual(V107)
40 (RS-232C)
25 (RS-422A/RS485)
5
(Unit mm)
WWW.NNC.IR
10
Aluminum foil tape
Appendices
A-9