Host Types And Settings Of Ethernet Unit - Omron NB3Q-TW00B Setup Manual

2-5-3

Host Types and Settings of Ethernet Unit

Units that are used for Ethernet communications vary according to the type and series of OMRON
PLC used.
When connecting an Ethernet Unit, check the series and type of the PLC that it will be connected to
and the model of the Unit that is mounted to the PLC.
NB-series PTs and the following Controllers can be connected with Ethernet units.
Series name
CS Series
CJ Series
CP1H Series
CP1L Series
CP1E Series
For details on the hosts that can be connected to NB-series PTs via the Ethernet, refer to A-5 List of
Models.
Host Settings
The types of hosts that can be connected to NB-series PTs with the Ethernet and the host settings
are as follows. The following settings must be set at the host.
Item
Number of nodes
Network number
UDP port number
IP address
Subnet mask
Default gateway
Node number
Note 1 The max total number of registered nodes by NB-Designer in the network is 33, at least 1 NB-series PT
and 1 host included.
2 If there is CP1E PLC in the actual network architecture, the Network No. must be set to 0.
3 The Node ID of 0 is equivalent to that of 1 (default).
NB-series Programmable Terminals Setup Manual(V107)
2 Installing the NB Unit and Connecting Peripheral Devices
Using the built-in board
—
—
CJ1M-CPU -ETN
—
—
—
CP1L-EL20
CP1L-EM30/40
—
Host Settings
33 (See note 1)
0 to 127 (See note 2)
1024 to 65535, default is 9600.
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0 to 254 (See note 3)
WWW.NNC.IR
Using an Ethernet Unit
CS1G/H-CPU (-V1)
CS1G/H-CPU H
CS1D-CPU H
CJ1G/H-CPU H
CJ1M-CPU (-ETN)
—
CJ2H-CPU (-EIP)
CJ2M-CPU
CP1H-Y
CP1H-XA
CP1H-X
CP1L-L14/20
CP1L-M30/40/60
—
CP1E-N30
CP1E-N40
CP1E-N60
CP1E-NA20
Ethernet Unit
CS1W-ETN21
CS1W-ETN21
CJ1W-ETN21
—
CJ1W-ETN21
CJ1W-ETN21
CP1W-CIF41
CP1W-CIF41
—
CP1W-CIF41
2-31
2