2 Installing the NB Unit and Connecting Peripheral Devices
Take the communication between single HMI and the PLC of Omron CJ2M-CPU33 (hereinafter
abbreviated as "PLC0") as example:
Configure the devices and set the communication parameters in the Construct Window, then click [Add]
in [HMI Attribute] - [HMI] - [Network Device Setting] to set parameters for HMI network-interface
communication.
HMI settings (sample)
Device Type
Device No.
HMI
HMI0
PLC
PLC0
Please note that the IP address set here should be same as the actual IP address of PLC during the
configuration. The result is shown as below:
2-30
IP Address
Port Number
192.168.250.1
9600
192.168.250.2
9600
WWW.NNC.IR
Communication
Mater/Slave
Protocol
Omron CJ Series
M(Master)
Fins UDP
Omron CJ Series
S(Slave)
Fins UDP (Slave)
NB-series Programmable Terminals Setup Manual(V107)
Station No. /
Node
Number
1
2