Settings For Each Unit - Omron NB3Q-TW00B Setup Manual

2-4-3

Settings for each Unit

When connecting with the serial communication ports, the settings for each Unit are as follows:
When connecting to CP-Series Units
CP1L-L14/L20/M30/M40/M60 models
CP1H-X40/XA40/Y20 models
CP1E-N14/N20 models
CP1E-N30/N40/N60/NA20 models
CP1E-EL20/EM30/EM40 models
PLC System Settings Area
Write settings directly into the [PLC System Settings Area] with a peripheral tool (CX-Programmer, etc.)
based on the model and port of the host.
Host model and Port No.
CP1L-M30/M40/M60, serial port 1
CP1H-X40/XA40/Y20, serial port 1
CP1L-EM30/EM40, serial port 1
CP1L-L14/L20, serial port 1
CP1L-M30/M40/M60, serial port 2
CP1H-X40/XA40/Y20, serial port 2
CP1L-EL20, serial port 1
CP1L-EM30/EM40, serial port 2
Host model and Port No.
CP1E-N14/N20, serial port 1
CP1E-N30/N40/N60/NA20,
serial port 1
CP1E-N30/N40/N60/NA20,
serial port 2
*1 The channel No. of CP1L/H is PLC Setup area.
*2 The communication speed should be set to the same value as that of the NB Unit.
Settings for the front-side DIP Switches
Set the front-side DIP switches so as to validate the settings for [PLC System Settings Area].
Set the SW4 to OFF when serial port 1 is used, set SW5 to OFF when serial port 2 is used. As the
CP1L-L has only one serial port, it has no DIP switch SW5.
NB-series Programmable Terminals Setup Manual(V107)
2 Installing the NB Unit and Connecting Peripheral Devices
Channel No. (*1)
144
145
147
160
161
163
Channel No.
A617.15~12
A617.11~08
A617.07~00
A618.15~12
A618.11~08
A618.07~00
CP1L-M
CP1H
WWW.NNC.IR
Write Value
8000 Use Host Link
0000~000A(*2) Communication speed
0000~001F Unit number
8000 Use Host Link
0000~000A(*2) Communication speed
0000~001F Unit number
Write Value
0 Use Host Link
0, 3~A(*2) Communication speed
00 7 data bits, 2 stop bits, Even
0 Use Host Link
0, 3~A(*2) Communication speed
00 7 data bits, 2 stop bits, Even
CP1L-L
Setting
Setting
2-13
2