Table of Contents
Advertisement
ALARM MODE - This function will enable the monitor to automatically bring the trouble location to
Full screen when a PIR Motion sensor camera detects movement. The letters AL will appear
At the top right corner of the screen and the camera location where the alarm has taken place
Will appear in the top left hand corner. An Alarm buzzer will sound to alert the user of an
Emergency situation. This alarm will sound for five seconds.
Individual selection of Alarm reset time and alarm ON/OFF can be done. Proceed to the Alarm
Mode menu to change these settings
Note: When motion has stopped, the monitor will automatically switch back to the previous
Mode in which it was set. Should additional triggers be received during subsequent periods
The system will automatically switch to the relevant cameras and continue the warning sound.
TIME/DATE - This function allows the user to set the date and time. Use the
(up,down)
and
(left, right) buttons to change settings. When complete, press the MENU button to
Exit the time/date menu
6. Microphone - Picks up sound around the monitor
7. Volume Control - Controls the Volume. Turn knob to reach the desired volume level.
8 Vertical Hold Control Knob Used to adjust vertical synchronization of the picture
9. Horizontal Position - Used to adjust the horizontal synchronization of the picture
10. IR Window - Receives signal from Remote Control
11. Contrast Control - Adjust the contrast picture. Turn knob to reach desired contrast level.
12. VCR ON/OFF Selector – Press this button to playback the video signal from the VCR.
To return, press the button again.
13. PAN /TILT ON OFF Selection - This feature does not work with this system
-7-
Advertisement
Table of Contents
