Preparing The Icemaker For Long Storage; Before Calling A Service Agent; Warranty - Hoshizaki FM-120EE Instruction Manual

* The water supply tap is on, and
* The icemaker is plugged into the power supply.
2. PREPARING THE ICEMAKER FOR LONG
STORAGE
) Run the icemaker with the water supply tap
closed.
2) Make sure the icemaking process has been
completed. Remove the Inlet Hose from the
water tap, and drain the Hose.
3) Unplug the icemaker.
4) Remove all ice from the Storage Bin, and clean
the Bin.
5) Ask for draining of the icemaker by professional
qualified personnel.
III. MAINTENANCE
1. CLEANING
WARNING
. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
m a i n t e n a n c e o p e r a t i o n s , u n p l u g t h e
icemaker from the electrical supply network.
2. Ask a trained service person to clean the
Condenser at least once a year.
3. This appliance must not be cleaned by use
of a water jet.
[1] Exterior
Wipe the exterior at least once per week with a
clean, soft cloth. Use a damp cloth containing a
neutral cleaner to wipe off grease or dirt.
[2] Storage Bin Interior Cleaning/Sanitisation
(as required)
) Open the Storage Bin Door, and remove all ice.
2) Remove the Drain Cap located in the base of
the Storage Bin.
3) Wash the Bin Liner, Plastic Spill Flap and Drain
Cap with a neutral non-abrasive cleaner. Rinse
thoroughly.
Note: Take care not to damage the Bin Control
Actuator at the top of the Bin.
4) Mix 5 litres of water with 8 ml of 5.25% sodium
hypochlorite solution in a suitable container.
5) Soak a clean sponge or cloth with the solution
and wipe all the surfaces of the Bin Liner, Plastic
Spill Flap and Drain Cap.
6) Refit the Drain Cap. Wipe the inside surface of
the Bin Door with the solution. Close the Bin
Door.
7) The remaining solution can be used to sanitise
utensils.
Note: Do not wipe dry or rinse after sanitising,
but allow to air dry.
[3] Storage Bin Door
Clean the Storage Bin Door at least once a week,
using a neutral non-abrasive cleaner. Rinse
thoroughly after cleaning and sanitise as required.
[4] Air Filter
A plastic mesh Air Filter removes dirt or dust from
the air, and keeps the Condenser from getting
clogged. As the Filter gets clogged, the icemaker's
performance will be reduced.
Contact an authorised Hoshizaki service company
to complete Air Filter cleaning as part of a regular
maintenance programme.

2. BEFORE CALLING A SERVICE AGENT

If the icemaker does not work properly or does not
work at all, before calling for service, check that:
* The power is supplied to the unit.
* The water is turned on.
For further assistance or advice, contact your local
Hoshizaki service agent.

3. WARRANTY

Hoshizaki warrants to the original owner/user that
all Hoshizaki branded products shall be free of
defects in material and/or workmanship for the
duration of the "warranty period". The warranty
3
ENGLISH