Checking The Configuration; Creating A Traffic Policy Based On Complex Traffic Classification - Huawei Quidway S9300 Configuration Manual

1 Class-based QoS Configuration
----End

1.4.5 Checking the Configuration

Prerequisite
The configurations of complex traffic classification are complete.
Procedure
l
l
----End
1.5 Creating a Traffic Policy Based on Complex Traffic
Classification
This section describes how to create a traffic policy based on complex traffic classification.
1.5.1 Establishing the Configuration Task
1.5.2 Configuring Complex Traffic Classification
1.5.3 Configuring a Traffic Behavior
1.5.4 Creating a Traffic Policy
1.5.5 Applying a Traffic Policy
1.5.6 Checking the Configuration
1-16
6. Run:
traffic classifier classifier-name [ operator { and | or } ]
[ precedence ]
A traffic classifier is created and the traffic classifier view is displayed.
The and parameter indicates that the relation between rules in a traffic classifier is
"AND". That is, the packets match a traffic classifier only when the packets match all
non-ACL rules and an ACL rule in the traffic classifier. The or parameter indicates
that the relation between rules in a traffic classifier is "OR". That is, the packets match
a traffic classifier when the packets match a rule in the traffic classifier.
By default, the relation between rules in a traffic classifier is "OR".
7. Run:
if-match acl mac-acl-number
A traffic classifier based on a MAC address ACL is created.
Run the display acl { all | acl-number } command to check the ACL rules.
Run the display traffic classifier { system-defined | user-defined } [ classifier-name ]
command to check the traffic classifier on the S9300.
system-defined indicates the traffic classifier defined by the system, and user-defined
indicates the traffic classifier defined by the user.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - QoS
Issue 03 (2009-08-20)