Figure 37
One on the pump
Note: Add no more than 2 squirts of grease to the pump.
Greasing the Boom Pivot Arms
The boom pivot arms are not greased at the time of factory
assembly and must be greased before use.
Grease Type: No. 2 general-purpose lithium base grease.
1. Manually place grease on the support shaft and within
the ball seat of the hinge plate as shown in Figure 1.
2. Pump grease into the fitting located below the spring
until grease can be seen coming out of the bottom of the
pivot assembly (Fig. 1).
3. Repeat the procedure for opposite pivot arm.
1
3
4
1
1. Support shaft
2. Ball seat of hinge plate
Note: The left pivot arm is shown in the figure above.
33
2
Figure 38
3. Grease fitting
4. Pivot assembly