Saving Energy And Paper - Lexmark XC8100 Series User Manual

Maintaining the printer
•
Any cart used to move the printer must have a surface able to support the full footprint of the printer.
•
Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.
•
Keep the printer in an upright position.
•
Avoid severe jarring movements.
•
Make sure that your fingers are not under the printer when you set it down.
•
Make sure that there is adequate clearance around the printer.
Note: Damage to the printer caused by improper moving is not covered by the printer warranty.
Shipping the printer
For shipping instructions, go to

Saving energy and paper

Setting up power saver modes
Eco‑Mode
1
From the home screen, touch Settings > Device > Power Management > Eco‑Mode.
2
Select a setting.
Sleep mode
1
From the home screen, touch Settings > Device > Power Management > Timeouts > Sleep Mode.
2
Enter the number of minutes the printer stays idle before it enters Sleep mode.
Hibernate mode
1
From the home screen, touch Settings > Device > Power Management > Timeouts > Hibernate Timeout.
2
Select the amount of time before the printer enters hibernate mode.
Notes:
•
Make sure to wake the printer from hibernate mode before sending a print job.
•
The Embedded Web Server is disabled when the printer is in hibernate mode.
Adjusting the brightness of printer display
1
From the homes screen, touch Settings > Preferences > Screen Brightness.
2
Adjust the setting.
http://support.lexmark.com or contact customer support.
101