Using Zone 2 - Onkyo TX-SR603/603E Instruction Manual

Zone 2 —Continued

Using Zone 2

Here you can turn on Zone 2, select an input source, and
adjust the volume.
1
2
Note:
To control Zone 2 with the remote controller, you must
press the [ZONE 2] button first.
1
Point the remote controller at the
ZONE 2
AV receiver and press the
[ZONE 2] button followed by the
[ON] button.
ON
This turns on Zone 2 and the AV
receiver's 12V TRIGGER OUT.
2 To select the Zone 2 input source
with the remote controller, press
2
ZONE
the [ZONE 2] button followed by
an input selector button.
If you select AM or FM, you can use
the remote controller's [TUNER] but-
ton to select the band.
To perform steps 1 and 2 on the
AV receiver, press the [ZONE 2]
button followed by an input
selector button within eight sec-
onds.
The name of the selected Zone 2 source
appears on the display.
76
3
4
ZONE 2
LEVEL - LEVEL +
1–4
4
ZONE 2
3
STANDBY
Notes:
• If the Sleep function has been set, the Zone 2 compo-
nent will turn off along with the AV receiver when the
specified sleep time expires. To use the Sleep function
with Zone 2 only, set the Sleep function and then set
the AV receiver to Standby.
• Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 SPEAKERS terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it's con-
nected to an analog input.
• While Zone 2 is being used, listening modes that need
surround back speakers (i.e., Dolby Digital EX and
DTS-ES) are unavailable.
• While Zone 2 is on,
• You can't select different radio stations for Zone 2 and
the main room. For example, if you have an FM sta-
tion for the main room, that station will also be used
in Zone 2.
To set Zone 2 to the same source as the
main room, press the [ZONE 2] button
repeatedly to display
"Zone 2 Sel: Source."
To adjust the Zone 2 volume with
the remote controller, press the
[ZONE 2] button, and then use
the [LEVEL–] and [LEVEL+] but-
tons.
To do this on the AV receiver,
press the ZONE 2 LEVEL [
buttons.
If the Zone 2 receiver/integrated amp is
connected to the AV receiver's ZONE 2
LINE OUT L/R jacks, use the volume
control on the receiver/integrated amp.
To turn off Zone 2 with the
remote controller, press the
[ZONE 2] button followed by the
[STANDBY] button.
To do this from the AV receiver,
press the [OFF] button.
functions will not work.
]/[ ]