Onkyo TX-SR603/603E Instruction Manual page 50

First Time Setup —Continued
Speaker Level Calibration
This setting is set automatically by the Automatic
Speaker Setup function (see page 39).
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Note:
The speakers cannot be calibrated while the output of the
AV receiver is muted, while a pair of headphones is con-
nected, or when using the multichannel input.
1
2
1
Press the [RECEIVER] button fol-
RECEIVER lowed by the [SETUP] button.
The main menu appears onscreen.
50
2
ENTER
ENTER
3
2, 3
ENTER
1, 5
4
5
Note:
This procedure can also be performed by using the
remote controller. First press the [TEST TONE] button
to output the test tone. Use the [LEVEL–] and
[LEVEL+] buttons to set the volume, and use the [CH
SEL] button to select the speakers.
Use the Up and Down [ ]/[
buttons to select "3. Level Cali-
bration," and then press
[ENTER].
The Level Calibration menu appears
and the pink noise test tone is output by
the front left speaker.
Note:
Speakers that you set to No or None on
the Speaker Configuration page
(page 46) cannot be selected.
Use the Up and Down [ ]/[
buttons to select each speaker,
and use the Left and Right [
[ ] buttons to set the volume.
The volume can be adjusted from –12
to +12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
Repeat step 3 until the volume of
the test tone from each speaker
is the same.
Press the [SETUP] button.
The setup menu closes.
]
]
]/