Onkyo TX-SR603/603E Instruction Manual page 40

First Time Setup —Continued
3 Press [ENTER].
ENTER
The automatic speaker setup starts.
The test tone is output by each speaker
in turn, measured by the microphone,
and the speaker settings set accordingly.
The whole process takes about 2 minutes.
If any extraneous noise is picked up by
the microphone, the automatic setup
may not work correctly, so be careful.
4 Once the measurement is com-
pleted, the following completion
screen appears.
ENTER
ENTER
Use the Up and Down [
buttons to select any of the fol-
lowing options, and then press
[ENTER].
Apply the Results:
Validates the measurement results and
closes the screen. Normally you may
want to select this option. Continue
with step 5.
Check the Results:
Displays the measurement results for
your reference. Continue with "How to
Verify the Measurement Results"
described below.
Retry:
Retries measurement. Return to step 2.
Retry with Test noise Level up:
Retries measurement with the test
sound at high volume level. Return to
step 2.
Cancel:
Closes the screen without validating
the measurement results. Continue with
step 5.
40
5
I How to Verify the Measurement Results
By selecting "Check the Results" at step 4, you can dis-
play the following screen to confirm the measurement
results.
ENTER
ENTER
]/[ ]
Disconnect the speaker setup
microphone.
To cancel the automatic setup while it's
in progress, disconnect the micro-
phone.
1 Warning
2 Number of speakers and their sizes
3 Distance from each speaker to the
listening position
4 The optimum volume level for each
speaker
5 The level adjustment for individual
frequency range covered by
respective speaker
Use the Up and Down [ ]/[
buttons to select the item that
you want to check, and then
press [ENTER].
Press the [RETURN] button to return to
the previous display.
]