Speaker Setup - Onkyo TX-SR603/603E Instruction Manual

First Time Setup —Continued
AM Frequency Step Setup
(some models only)
Here you can specify the AM frequency step used in
your area. When this setting is changed, all radio presets
are deleted.
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "0. Initial
Setup," and then press [ENTER].
ENTER
The Initial Setup menu appears.
ENTER
3
Use the Up and Down [
buttons to select "i. AM Freq
Step," and then use the Left and
ENTER
Right [
10 kHz: Select if 10 kHz steps are
9 kHz: Select if 9 kHz steps are used
4 Press the [SETUP] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
46
]/[ ]
]/[ ]
]/[ ] buttons to select:
used in your area.
in your area.

Speaker Setup

Some of the settings in this section are set automatically
by the Automatic Speaker Setup function (see page 39).
Here you can check the settings made by the Automatic
Speaker Setup function, or set them manually, which is
useful if you change one of the connected speakers after
using the Automatic Speaker Setup function.
Speaker Configuration
This setting is set automatically by the Automatic
Speaker Setup function (see page 39).
Here you can specify which speakers are connected and
their individual sizes.
For speakers with a cone diameter
over 6-1/2 inches (16 cm), specify
large, and for those with a diameter
below this, specify small.
1
2
1 Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
Cone diameter
2–10
1, 11