Table of Contents
Advertisement
Fuel System
Maintenance
WARNING
Fuel-system components are under high
pressure. The use of improper components
can result in system failure, fuel leakage, and
possible explosion.
Use only approved fuel lines and fuel filters.
Servicing the Electronic
Fuel-Injection System
This machine contains an electronic fuel-injection
system. It controls the fuel flow under different
operating conditions.
The electronic-control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) illuminates. The MIL
is the red light located in the right console panel.
Once the MIL illuminates, make initial troubleshooting
checks; refer to the MIL section under
(page
71).
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
Replacing the
Low-Pressure Fuel Filter
Service Interval: Every 200 hours/Yearly (whichever
comes first)
The fuel filter is located near the engine on the front
or rear side of the engine.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Wait for the machine to cool down.
4.
Close the fuel-shutoff valve under the seat
(Figure
57).
1. Fuel filter
2. Hose clamp
5.
6.
7.
8.
Troubleshooting
Important:
with plastic ties the same as they were originally
installed at the factory to keep the fuel line away
from components that can cause fuel line damage.
Servicing the
High-Pressure Fuel Filter
Do not attempt to service the high-pressure fuel
filter. The high-pressure filter is integrated within
the fuel-pump module. The fuel filter and other
components inside the fuel-pump module are not
serviceable.
Important:
-
EUTRAL
LOCK
module.
Ensure that an Authorized Service Dealer replaces
the fuel-pump module with the high-pressure fuel filter.
Servicing the Fuel Tank
Do not attempt to drain the fuel tank. Ensure that an
Authorized Service Dealer drains the fuel tank and
services any components of the fuel system.
45
Figure 57
Squeeze the ends of the hose clamps together
and slide them away from the filter
Remove the filter from the fuel lines.
Install a new filter and move the hose clamps
close to the filter
(Figure
Open the fuel-shutoff valve.
Install the fuel line hoses and secure
Do not attempt to open the fuel-pump
g008963
3. Fuel line
(Figure
57).
57).
Advertisement
Table of Contents
