Controls System Maintenance; Adjusting The Control Lever Neutral Interlock Switch; Adjusting The Control Lever Neutral Return - Toro 30360 Operator's Manual

Controls System
Maintenance
Adjusting the Control Lever
Neutral Interlock Switch
1. Stop the machine, move the deck lift switch fully into
the neutral-locked position, set the parking brake, and
remove the ignition key.
2. Remove the bolts securing the front panel and remove
the panel (Figure 56).
2
1
Figure 56
1. Bolts
2. Control panel
3. Loosen the 2 screws securing the interlock switch
(Figure 57).
1. Control lever
2. Neutral interlock switch
4. Holding the control lever against the frame, move the
5. Secure the switch.
G020875
6. Repeat steps 3 to 5 for the other lever.
7. Install the front panel.
Adjusting the Control Lever
Neutral Return
If the motion control levers do not align with the neutral slots
when released from the reverse drive position, adjustment is
required. Adjust each lever, spring, and rod separately.
1. Disengage the PTO, move the control lever to the
2. Move the throttle lever to the Slow position, stop the
3. Remove the bolts securing the front panel and remove
50
Figure 57
switch toward the lever until the distance between lever
and switch body is 0.4 to 1 mm (0.015 to 0.045 inch)
(Figure 57).
neutral locked position, and set the parking brake.
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
the panel (Figure 58).
3. Screws
4. 0.4 to 1 mm (0.015 to
0.045 inch)