Changing The Hydraulic Oil And Filter - Toro 30360 Operator's Manual

Figure 66
1. Dipstick
6. Remove the dipstick and wipe it with a clean rag
(Figure 66).
7. Place the dipstick into the filler neck; then remove it
and check level of fluid (Figure 66).
Note: If level is not within notched area of the
dipstick, add enough high quality hydraulic fluid to
raise level to within the notched area. Do not overfill.
8. Replace the dipstick and thread the fill cap finger-tight
onto filler neck.
9. Check all hoses and fittings for leaks.
Changing the Hydraulic Oil
And Filter
Service Interval: After the first 200 hours
Every 800 hours
1. Disengage the PTO, move the motion control levers to
the neutral locked position, and set the parking brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Place a large pan under the hydraulic reservoir and
transmission case and remove the plugs, draining all of
the hydraulic fluid (Figure 67).
2. Fill cap
1. Hydraulic reservoir drain
plug
2. Filter
4. Clean the area around the hydraulic oil filter and
remove it (Figure 67).
5. Immediately install a new hydraulic oil filter.
6. Install the hydraulic reservoir and transmission case
drain plugs.
7. Fill the reservoir to the proper level; refer to Checking
the Hydraulic System (page 22).
8. Start the engine and check for oil leaks. Allow the
engine to run for about five minutes, then shut it off.
9. After 2 minutes, check the level of the hydraulic fluid;
refer to Checking the Hydraulic System (page 22).
55
Figure 67
3. Transmission case drain
plug