Servicing The Engine Oil And Filter - Toro 30873 Operator's Manual

1. Air-cleaner safety filter
5. Clean the dirt-ejection port located in the removable
cover.
6. Remove the rubber outlet valve from the cover, clean
the cavity, and install the outlet valve.
7. Install the cover, orienting the rubber outlet valve in a
downward position—between approximately 5:00 to
7:00 when viewed from the end.
8. Reset the indicator
Servicing the Engine Oil and
Filter
Service Interval: After the first 50 hours
Every 150 hours
1. Remove the rear drain plug
flow into a drain pan. When the oil stops, install the
drain plug.
1. Engine oil drain plug
Figure 36
(Figure 33) if it shows red.
(Figure 37) and let the oil
Figure 37
2. Remove the oil filter
Note: Apply a light coat of clean oil to the new filter
seal before screwing it on. Do not overtighten the filter.
1. Engine oil filter
3. Add oil to the crankcase; refer to
Engine-oil Level (page
41
(Figure 38).
Figure 38
Checking the
27).