Toro 30873 Operator's Manual page 39

•
Steering-cylinder ball joints (2)
1. Top fitting on kingpin
•
Tie-rod ball joints (2)
•
Kingpin bushings (2)
the king pin should only be lubricated annually
(2 pumps).
•
Lift-arm bushings (1 per deck)
•
Lift-cylinder bushings (2 per deck)
(Figure 29)
Figure 29
(Figure 29)
(Figure 29). The top fitting on
(Figure 30)
Figure 30
(Figure 30)
•
Cutting-unit spindle-shaft bearings (2 per cutting unit)
(Figure 31)
Note: Either fitting can be used, which ever is more
accessible. Pump grease into the fitting until a small
amount appears at bottom of the spindle housing (under
the deck).
•
Cutting-unit carrier-arm bushings (1 per cutting unit)
(Figure 31)
•
Rear roller bearings (2 per cutting unit)
Important: Make sure that the grease groove in
each roller mount aligns with the grease hole in each
end of the roller shaft. To help align the groove and
the hole, there is also an alignment mark on 1 end of
the roller shaft.
39
Figure 31
(Figure 32
Figure 32
)