Table of Contents
Advertisement
Caution
Shut the engine off and wait for all moving parts to
stop before checking for oil leaks, loose parts, and
other malfunctions.
Checking the Interlock System
Operation
Caution
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
• Replace switches every two years regardless of
whether they are operating properly or not.
The purpose of the interlock system is to prevent the engine
from cranking or starting unless the traction pedal is in the
neutral position.
1. Check the interlock operation in a wide open area free
of debris and bystanders. Stop the engine.
2. Sit on the seat. Depress the traction pedal in forward
and reverse while trying to start the engine. If the
engine cranks, there may be a malfunction in the
interlock system. Repair it immediately. If the engine
does not crank, the system is operating correctly.
Towing the Machine
In case of emergency, the machine can be towed for a short
distance. However, we do not recommend this as a standard
procedure.
Important
Do not tow the machine faster than
2–3 MPH (3–5 km/h) because the drive system may be
damaged. If the machine must be moved a considerable
distance, transport it on a truck or trailer. The tires may
lock up if the machine is towed too fast. If this occurs, stop
towing the machine and wait for the traction circuit
pressure to stabilize before resuming towing at a slower
speed.
Break-In Period
Only 8 hours of operating time is required for the break-in
period.
Since the first hours of operation are critical to future
dependability of the machine, monitor its functions and
performance closely so that minor difficulties, which could
lead to major problems, are noted and can be corrected.
Inspect the machine frequently during break-in for signs of
oil leakage, loose fasteners, or any other malfunction.
Operating Characteristics
Practice driving the machine because its operating
characteristics are different than some utility vehicles. Two
points to consider when operating the vehicle are
transmission and engine speed.
To maintain somewhat constant engine RPM, depress the
traction pedal slowly. This allows the engine to keep up
with the ground speed of the vehicle. By contrast, pushing
down quickly on the traction pedal will reduce engine RPM
and, as a result, there will not be enough torque-power to
move the vehicle. Therefore, to transfer maximum power to
the rear wheels, move the throttle to Fast and slightly
depress the traction pedal. By comparison, maximum
ground speed with no load results when the throttle is in the
Fast position and the traction pedal is slowly but fully
depressed. In summary, always keep the engine RPM high
enough to deliver maximum torque-power to the rear
wheels.
Caution
Operating the machine demands attention to
prevent tipping or loss of control.
• Use care when entering and leaving sand traps.
• Use extreme caution around ditches, creeks, or
other hazards.
• Use caution when operating the machine on a
steep slope.
• Reduce your speed when making sharp turns or
when turning on hillsides.
• Avoid sudden stops and starts.
• Do not go from reverse to full forward without
first coming to a complete stop.
Inspecting and Cleaning the
Machine
At the completion of operation, thoroughly wash the
machine with a garden hose—without a nozzle—so that
excessive water pressure will not cause contamination and
damage to the seals and bearings.
Make sure that the cooling fins and area around the engine
cooling air intake are kept free of debris. After cleaning,
inspect the machine for possible hydraulic fluid leaks,
damage, or wear to hydraulic and mechanical components.
16
Advertisement
Table of Contents
