Adjusting The Anti-Scalp Rollers; Positioning The Seat - Toro 74141 Operator's Manual

Adjusting the Height-of-Cut Pin
Mower deck size Height-of-cut
range
48-inch deck 38 to 127 mm
(1-1/2 to 5 inches)
52-inch and 38 to 140 mm
60-inch decks (1-1/2 to 5-1/2
inches)
The height-of-cut is adjusted from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by relocating
the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
2. Push on the deck-lift pedal with your foot, and raise the
mower deck to the transport position (also the 140 mm
(5-1/2 inches) cutting height position) as shown in
Figure 25.
3. To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket
4. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired, and insert the pin
25).
5. Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
3
1
Figure 25
1. Deck-lift pedal
2. Cut-of-height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position,
and set the parking brake.
Increments
6 mm (1/4 inch)
6 mm (1/4 inch)
(Figure 25).
(Figure
g017419
3. Transport lock
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
1. Anti-scalp roller
2. Spacer
3. Bushing
1. Anti-scalp roller
2. Bushing

Positioning the Seat

2
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat
G008962
24
g017628
Figure 26
4. Flange nut
5. Bolt
Figure 27
3. Flange nut
4. Bolt
(Figure
Figure 28
g017629
28).