Using The Fuel Shutoff Valve; Starting And Stopping The Engine - Toro 74141 Operator's Manual

Using the Fuel Shutoff Valve

The fuel shutoff valve is located behind the seat.
Close the fuel shutoff valve for transport, maintenance, and
storage.
Ensure that the fuel shutoff valve is open when starting the
engine.
1
2
G008948
Figure 17
1. On position
Starting and Stopping the
Engine
Starting the Engine
1. Raise the ROPS up and lock into place, sit on the seat,
and fasten the seat belt.
2. Move the motion controls to neutral-locked position.
3. Set the parking brake; refer to
Brake (page 18).
4. Move the blade-control switch (PTO) to the Off
position (Figure 18).
5. Move the throttle lever midway between the Slow and
Fast positions.
G017428
2. Off position
Setting the Parking
6. Turn the ignition key to the Start position
Note: When the engines starts, release the key.
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
1. Off
2. Run
20
Figure 18
(Figure
G008947
Figure 19
3. Start
19).