Adjusting The Handle Height; Starting The Engine; Using The Self-Propel Drive; Stopping The Engine - Toro Super Recycler 20383 Operator's Manual

Adjusting the Handle Height

You may raise or lower the handle to a position comfortable
for you.
Rotate the handle lock, move the handle to 1 of 3 positions,
and lock the handle into position
1. Handle lock

Starting the Engine

Pull the recoil-start handle
Note: If the machine does not start, contact an Authorized
Service Dealer.
(Figure 15).
Figure 15
2. Handle positions
(Figure 16).
Figure 16

Using the Self-Propel Drive

To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine will automatically keep pace with you

Stopping the Engine

Service Interval: Before each use or daily
If the ignition switch on your machine
switch (with both an "I" and a "Stop"), push the switch to the
Stop position. Otherwise, hold down the switch in the Stop
position until the engine stops.
1. Ignition-toggle switch
11
(Figure
Figure 17
(Figure 18) is a toggle
G017317
Figure 18
17).