Assembling And Unfolding The Handle - Toro Super Recycler 20383 Operator's Manual

2
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• Ensure that the cables are routed to the outside
of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the machine housing to its
highest cutting-height setting by moving the 2 rear
cutting-height levers all the way forward. Refer to
Adjusting the Cutting Height (page
2. Attach the handle ends to the machine housing with
2 washers and 2 handle bolts
tighten the handle bolts.
1. Washer
2. Handle bolt
Important: Route the cables to the outside of the
handle (Figure 4).
3. Rotate the handle rearward
10).
(Figure 4), but do not
G017457
Figure 4
3. Handle end
(Figure 5).
4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height (page
5. Torque the handle bolts to 14 to 17 N-m (120 to 160
in-lb).
6. Adjust the cutting height. Refer to
Cutting Height (page
6
G017458
Figure 5
11).
Adjusting the
10).