Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro Super Recycler 20383 Operator's Manual

3
Installing the Recoil-Starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Pull the recoil-starter rope through the rope guide on the
handle (Figure 6).
1. Recoil-starter rope
Figure 6
2. Rope guide
4

Filling the Engine with Oil

No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
with oil.
1. Move the machine to a level surface.
2. Remove the dipstick
the crankcase capacity of oil into the oil-fill tube.
Note: Max. fill: 0.59 L (20 oz), type: SAE 30 or SAE
10W-30 detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.
1. The oil level is at its
maximum.
2. The oil level is too
high—remove oil from
the crankcase.
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in.
5. Remove the dipstick and read the oil level on the
dipstick (Figure 7).
•
If the oil level is too low, add a small amount of
oil slowly to the oil-fill tube, and then repeat steps
3 through 5
correct.
•
If the oil level is too high, drain the excess oil until
the oil level on the dipstick is correct. To drain the
7
(Figure 7) and pour about 3/4 of
G017459
Figure 7
3. The oil level is too
low—add oil to the
crankcase.
until the oil level on the dipstick is